What is the main port on CC3D?
Table of Contents
MainPort (also previously known as Telemetry): JST-SH 4-pin. This is a serial USART whose baud rate can be adjusted through the GCS. Optionally Futaba S. Bus receiver, Spektrum/JR satellite receiver or GPS can be mapped to the MainPort.
Does sbus have telemetry?
Simply connect SBUS to any free UART RX pin on the FC (or the dedicated SBUS pin if there is one), and Smart port to another free UART TX (not on the same UART as SBUS). And select SmartPort as the Telemetry Output option in the UART you have chosen for SPort.
What is SmartPort drone?
Posted on 2016-06-26 by Jay. The Frsky XSR – also known as the X4RS (rev1) – is a new Receiver from FrSky that is super light and small, and gives you up to 16 channels for a drone. It uses the dreaded smartport for telemetry though as does all the X series from Frsky.
Does sbus go to RX or TX?
Simply connect SBUS to any free UART RX pin on the FC (or the dedicated SBUS pin if there is one), and Smart port to another free UART TX (not on the same UART as SBUS). The same procedure goes for both X4R-SB and XSR RX.
What is the main port on cc3d?
How do you flash Cleanflight?
Connect the flight controller board to the PC. Ensure the correct serial port is selected. Click on the “Flash Firmware” button and hold still (do not breathe, too). When the progress bar becomes green and reads “Programming: SUCCESSFUL” you are done!
How do I get cleanflight onto a CC3D board?
There are two primary ways to get Cleanflight onto a CC3D board. Single binary image mode – best mode if you don’t want to use OpenPilot. OpenPilot Bootloader compatible image mode – best mode if you want to switch between OpenPilot and Cleanflight. Single binary image mode.
How to flash cleanflight?
Before flashing CleanFlight, you want to backup your settings (PID values, CLI variables etc). 2. Disconnect battery, connect USB cable to power the board. 3. In CLI command, dump your configs for each profile, and save to text file.
How to enable soft serial telemetry in cleanflight?
In the Cleanflight you have select Telemetry and softserial on Configuration tab. On Ports Tab select Softserial telemetry select SMART PORT, AUTO. On CLI select FRSKY Telemetry Invert = ON tlm_inversion = ON or 1, depending the Cleanflight version. Latest version he changed to ON and OFF and not more 0 and 1.
How do I import my aux configs into cleanflight?
In CLI command, dump your configs for each profile, and save to text file. Also take screenshots of your AUX settings so you can set it up in CleanFlight later, note that AUX settings are not backwards compatible. After flashing CleanFlight, paste the output of your first profile into CLI.