What does blinking flame mean on thermostat?
Table of Contents
The flame icon on your the thermostat flashes when the compressor is locked. This can occur as a result of power loss or interruption. In other words, if the flame icon on your thermostat is blinking, your compressor is likely cut and you will need to reset your thermostat to reactivate it.
Why is my White Rodgers thermostat blinking?
If you see a flashing light on your thermostat, that’s a signal that there’s a problem with your outdoor unit. When this happens, your outdoor unit will shut off and send a signal to your thermostat, causing it to blink.
What does little flame on White Rodgers thermostat mean?
The flame may indicate the thermostat is calling for 2nd stage heat. If something isn’t working (or if there is no heater package installed) then a drop in house temperature can be expected. The drop in temperature justifies a repair call.
How do you program a White Rodgers thermostat?
To do this, follow these steps:
- Press the “TIME” button.
- Now, use the Up and Down arrows to set the proper hour.
- Press “TIME” again to set the hour and move onto setting the minutes.
- Use the arrow keys again to set the correct minute. Press “TIME” to confirm the changes.
- Press “RUN” to confirm the time setup.
How do I fix my White Rodgers thermostat?
Usually, most White-Rodgers thermostats follow a somewhat standard procedure to reset. You can reset your White-Rodgers thermostat by pressing and holding the down arrow and the time key on the thermostat until the display goes blank.
Why does my White Rodgers thermostat reset itself?
If your thermostat keeps resetting itself, the chances are that it is either needs to be reprogrammed, has bad batteries, bad wiring, or a bad fuse. It’s best to troubleshoot all of these issues before reaching out to a technician, as it may save you time on repair costs.
Why is my White Rodgers thermostat not working?
You can reset your White-Rodgers thermostat by pressing and holding the down arrow and the time key on the thermostat until the display goes blank. Consult the manual for your White-Rodgers thermostat to know how to reset your model of thermostat.
What do the water drops on thermostat mean?
Water Drop Symbols Usually, what this symbol means is that the air conditioner is running in dry mode to remove excess moisture from the air. The system will continue to cool during this time, so cold air should still be coming out of the vents.
How do I Reset my White Rodgers thermostat?
How To Move A Thermostat Without Rewiring
Why is my white Rodgers thermostat not working?
Common Issues. First,make sure that the power supply to your house or business is still on if,in fact,the HVAC is not working at all.
How to troubleshoot a white-Rodgers thermostat?
Basic Troubleshooting Steps. First,check whether the power supply of the area/business/house is running.
How to troubleshoot white Rodgers thermostat?
Dead batteries. The first thing to check when your White Rodgers thermostat goes blank is dead batteries.