How much does it cost to fix a broken sink stopper?

You’ll need to spend between $25 – $60 to replace your bathroom sink stopper. Depending on whether you choose to replace just your stopper, the entire stopper assembly, and other pipes, your cost will vary.

Can you replace just the stopper in a sink?

Lift the sink drain stopper out of the drain. Inspect the rubber seal on the bottom of the stopper head. If the seal is cracked or brittle, the stopper should be replaced. If it’s still in good condition, you can reuse it.

How do I fix a bathroom sink stopper?

Detach the pivot rod from the clevis by removing the spring clip. The clevis is the vertical metal bar that the horizontal pivot rod attaches to beneath the sink.

Put the spring clip on the end of the pivot rod. Slide the pivot rod through one of the holes in the metal clip.

Align the pivot rod with one of the holes in the clevis.

How to replace a broken bathroom sink stopper?

To replace a sink stopper, first, follow the vertical bar of the stopper beneath your sink. Then, undo the clamp that connects the bar to the angled rod that enters the drainpipe by pinching and separating it.

How to fix sink stopper that will not stay up?

Understand a bit of what’s going on under your sink.

Push and pull the rod. Notice whether the drain stopper moves.

Adjust the nut. On the back of the drainpipe,there is a nut.

Make sure the two rods are connected.

Attach the stopper to the lower rod.

Adjust the location of the lower rod.

Adjust the travel of the lower rod.

How to take out a stuck sink stopper?

How to take out a stuck sink stopper. Move the rod to a different hole while you’re replacing the spring clip. Push up on the drain while pulling it out of the top. Drain pop up sink stopper is stuck down. Undo the screw holding the extension bar and lift out the drain stopper. Get a drain rooter from amazon if it’s also clogged: Go ahead and