How do you make a paper plate spinner?

Table of Contents

What to do

Grab a paper plate and cut out the inner circle of your plate.
Draw a pattern onto your plate and then paint it.
If your like you can paint different patterns on each side, or the same on both.
Using a sharp object make two small holes approximately 1cm on either side of the center of the paper plate.

How do you make a spinner without a Brad?

A Split-Pin and Paper Clip Make a hole in the centre of the spinner. Take a split pin and insert it though the narrowest loop of a paper clip. Then push the split pin through the hole in the spinner. Make sure not to push it through completely – ensure there is a small gap to allow the paper clip to spin freely.

How to make your own spinner?

Make a hole in the centre of the spinner. Take a split pin and insert it though the narrowest loop of a paper clip. Then push the split pin through the hole in the spinner. Make sure not to push it through completely – ensure there is a small gap to allow the paper clip to spin freely. Turn the spinner over and open the two feet of the split

How to make spinner at home?

Since a Single Layer of Paper is Weak i Added nearly 18 Pieces Which Were Individually Glued Together

At The End of body Coin Is Kept and Impressions Are Taken

To Cut Many Layers Of Paper At Once Check The Process in Images (Done With One More Sheet)

Process Needs Time and Patience

Glued Using Paperglue

Left For Sometime To Dry

How to make your own inline spinners?

Cost-cutting;

Making money;

Availability;

Personal satisfaction;

How to make an inline spinner?

French blades. I like the smallest you can find (0),as I’ve always had better success with smaller spinners.

Clevises. Same place you get the blades,get the smallest you can,though size isn’t a big issue.

Stainless wire. For these lures,breaking strain isn’t important.

Beads.

Weights.

Hooks.

Split rings.