What does low burn air mean on pellet stove?

What does low burn air mean on pellet stove?

The flame on a pellet stove needs to be hot — but not too hot. A low-burning, flickering orange flame, known as a “lazy” flame, is not hot enough to be efficient. A lazy flame usually has black tips or emits dark black smoke. This kind of flame needs more air for the pellet stove to be efficient.

What should the settings be on my Englander pellet stove?

The factory settings are 6 on the LFF, 4 on the LBA and 1 on the AOT. If for some reason these setting are out of adjustment they can be readjusted back to the factory settings.

What is the best setting for my pellet stove?

Proper placement, correct installation, fuel quality and scheduled maintenance will result in pellet stove operating at peak performance and efficiency. It is best to run the appliance on the lower heat settings like 2 or 3 rather than up at 4 or 5.

What does air on temp do on pellet stove?

Air Inlet for Greater Temperature Control The air inlet setting on a pellet stove permits you to allow more or less air into the unit. When allowing more air into the pellet stove, temperatures will be hotter. The air inlet setting gives you more control over the temperature of the fire in the stove.

How do I increase the airflow in my pellet stove?

The Solution Clean your stove according to your manufacturer’s recommendations. Adjust heat setting to medium or medium/high. Clean all vents, check and repair/replace all gaskets, adjust damper or airflow setting. Adjust air-to-pellet ratio by increasing air flow.

How high should the flame be on my pellet stove?

4′-6”
Once the feeding of pellets is re-established and the stove is running on High, the flame should rise to 4′-6” above the top of the firepot. If not, it may be necessary to adjust the pellet feed rate.

How do I get the most heat out of my pellet stove?

5 Ways To Get More Heat From A Pellet Stove

1. Burn high quality pellets low in ash and moisture content.
2. Increase the heat output setting on the stove.
3. Increase the blower speed on the stove.
4. Adjust the airflow in and out of the stove.
5. Clean the stove regularly in line with the manufacturer’s guidelines.

What is the feed rate on a pellet stove?

The feed adjuster on a Harmon pellet stove determines the feed rate of the pellets into the combustion chamber of the stove. If the feed rate is set too high, partially burned pellets will be pushed off the end of the burn pot, wasting fuel. The stove may also smoke.

Is a cold air intake necessary for a pellet stove?

The use of an Outside Air Kit may not be required in certain cases, but it is highly recommended in all installations. An Outside Air Kit feeds uninterrupted combustion air into your appliance from outside your home, helping to maintain proper air/fuel balance and ensure even burning.

Why are my pellets not burning?

If your pellet stove isn’t burning well A blocked air inlet cap also could be to blame. If your inlet cap becomes blocked, you might notice that pellets are not burning entirely. Clean the cap manually to make sure it is not blocked, and inspect it for any damage or leaks.