How do I pair my heart rate monitor to my Garmin Edge 800?

How do I pair my heart rate monitor to my Garmin Edge 800?

Select MENU > > Bike Settings > Heart Rate > ANT+ Heart Rate. 4. Select Heart Rate Monitor > Yes.

How do I reset my Garmin sensors?

Reset the Sensor

1. Remove the battery from the ANT+ sensor.
2. Leave the battery out of the sensor for 5 minutes.
3. Reinstall the battery.

How do I reset my Garmin 800?

To perform the master reset:

1. Power device off.
2. Press and hold Lap/Reset and Start/Stop.
3. Power device on while still holding both buttons.
4. Continue holding buttons when the Garmin “splash” screen appears.
5. Release buttons when Garmin “splash” screen disappears.

How do you wake up Garmin sensors?

Rotate the crank arm or wheel two revolutions to wake up the sensor. The LED flashes green for five seconds to indicate activity. The LED flashes red to indicate a low battery level. If available, pair the sensor using ANT‍+ technology.

Where is the Garmin Heart Rate sensor ID?

If you use your HR strap with a Garmin device, such as a fitness watch or bike computer, you may look up the sensor ID within the device settings. The sensor ID location varies from device to device, but should be found under the sensor list or within the HR pairing screen.

Does your Garmin HRM stop recording heart rate?

I have a Garmin HRM connected to a Garmin 800. A while back I noticed my heart rate would sporadically stop recording, when it did record I noticed my heart rate was much, much lower than one would expect.

Why does my heart sputter when I Wear my Garmin?

It must be some aspect of heart rhythm is triggering the spikes. If its not A-Fib or tachycardia or some other disease process. It must be this bigeminy rhythm. Garmin devices must be picking this up either strap wise or device wise. Since its not reported with another type of strap. There might be some quality of the Garmin product doing this.

Is the Garmin HRM dual heart rate monitor compatible with HRV logger?

I have several Garmin HRM Dual heart rate monitors. I have had no problem at all looking at HRV in the iOS versions of HRV Logger or HRV4Training. Both work flawlessly. I have also connected to Strava, Wahoo Fitness, Zwift, TrainerRoad, and Sufferfest on iOS and Windows 10 over BT with no problems.

Can I use a cheap HRM monitor with my original sensor?

So if your cheap HRM monitor has the similar format where you can use your original HRM sensor, you could try to swap them and see where the problem is in the sensor unit or the strap, just an idea.